- Topic
- Replies
- Since
Scotsman PCB ASSY CLEANING AC/EC 46/56/86/OX PC BOARD
Posted by: adminWhen replacing the board a new condenser sensor ( grey cable) needs to be replaced as well The old board has a black cable and they are not interchangeable
- 0
why would a Manitowoc ice machine have 2 floats
Posted by: adminHarvest Float (often the rear/side one, red wire in many units): Signals the control board to start the harvest cycle once the ice sheet is ready. It detects when the ice has built up enough...
- 0
EC47 scotsman ice machine YELLOW FREEZING LED AND RED ALARM LED BLINKING
Posted by: admin[video width="478" height="850" mp4="https://www.chat.icemachine.co.za/wp-content/uploads/2026/06/flashing.mp4"][/video] try unplugging the machine from the wall for 10 mins and start it again, make sure water is on and water pressure from tap is ok, if the error persists the...
- 0
what do you recommend for a small lodge
Posted by: adminwhat do you recommend for a small lodge How many people a day. Or how many kg of ice a day. Restaurant, bar 🍸 environment, Do customers take ice for rooms best for larger establishments is an...
- 0
C1448 / C1848 No 8 code flashing
Posted by: admin[video width="358" height="642" mp4="https://www.chat.icemachine.co.za/wp-content/uploads/2026/05/C1448-No-8-code-flashing.mp4"][/video] ice is to thin and machine goes into harvest to quick have you cleaned the spray bar the water must fall down the plate the whole width [ratemypost]
- 0
- Posted by: admin
the red light flashes with no other lights flashing
- 0
- Posted by: admin
When you decide to start an ice business the ideal machine to use would be an 320 kg per 24 hours machine and a 320 kg bin (B320). These machines are single phase 220 volt machines...
- 0
Scotsman ice machine parts manuals can be found here
Posted by: adminhttps://www.icemachines.co.za/2026/04/27/scotsman-ice-machine-parts-manuals/ [ratemypost]
- 0
Scotsman ice machine service manuals can be found here
Posted by: adminhttps://www.icemachines.co.za/2026/05/04/scotsman-ice-machine-service-manuals/ [ratemypost]
- 0
MXG red and yellow lights flashing
Posted by: admin[video width="474" height="850" mp4="https://www.chat.icemachine.co.za/wp-content/uploads/2026/05/1.mp4"][/video] [ratemypost]
- 0
Installation instructions for Ice Makers
Posted by: adminThe following on-site services are required within one meter of the location of the unit. Our quote does not cover the provision of these services. -Water point (tap) ¾” male thread -Ground/ floor Level Water Drain – gravity feed -Electricity Supply –...
- 0
- Posted by: admin
does the whole plate ice up top to bottom ( if not then you need to get gas checked) is the condenser clean, washed with a hosepipe properly not just dusted ( switch...
- 0